Finally got it to work. I think that on a previous try and failure, my credentials were saved while I had gone back and recover everything over. Cleared out the old credentials, started all over and worked!

This is good to know the next time around. Thanks!

I’ve double-checked settings.

I can select the Google Nest Integration. I enter my Cloud Project ID and click Submit with no error. I am then prompted for my Device Access Project ID, which I enter and click submit. I am then presented with a screen from Google saying that it can’t link to project. No other information and no error. Nothing in the home assistance core logs. I’ve double checked the settings and I know that Project ID is correct as it returns the project name that I set, “HA Nest Project”.

Not really sure where to look for issues - any suggestions are appreciated.

Just upgraded to the latest update. Running: Core 2024.3.0 Supervisor 2024.02.1 Operating System 12.0 Frontend 20240306.0

Same here except all 4 are in a ceiling fan. To turn them all on and off at the same time, I’ve named them the Fan Four.

Pete is a lone, recessed light in the corner.

Two lamps with pineapple motifs are Bob and Liz. Two lamps in bedroom are Harold and Maude.

One floor lamp is Slim "Shady“.

As a follow up, this worked as you described. Thanks again.

Now, since it’s the shortcut button, I had to load the blueprint and start working on the proper configuration so that I can do more with the switch - for example, double clicks, holding, etc…

Not quite there yet, but your response helped a lot.

Awesome advice! Thank you - I will give it a try now.