Smart soldering irons have been around a while, so yes. It is now like a PC and specs matter a little.
One advantage smart irons have is being able to give you a readout of the exact temp of the tip of your soldering iron, something a traditional iron cannot do.
It also needs chips and sensors to do things like auto-off when it is set down.
So the quality and speed of chips affects performance.
The Weller WESD51 sets the temp at the tip and mine has done that since I bought it in 2016. A look at a datasheet dates it back to 2006 but it could be older. By definition that means it has to know what the tip temp is. As it heats up the digital display tracks the temp going up.
If it has digital temperature control then it has something resembling a CPU and memory. If it’s analog then it’s probably just not that accurate and will drift over time without manual calibration.
I have a pinecil and direct heat soldering irons blow away non direct heat irons like your weller (and I think this ifixit one). Once you switch you never want to go back. Which is really disappointing because I don’t think this new ifix it one is.
Those look pretty cool.
But I’m confused about the marketing around the cpu/ram, etc. Does that really matter for a soldering iron? (Serious question, not being snarky).
I get they’re using that tech to make it adjustible/smart, but it’s a soldering iron, not a pocket computer.
Is there some way those specs genuinely matter? Or is it just to say “we’re using the latest tech to provide controls”?
Smart soldering irons have been around a while, so yes. It is now like a PC and specs matter a little.
One advantage smart irons have is being able to give you a readout of the exact temp of the tip of your soldering iron, something a traditional iron cannot do.
It also needs chips and sensors to do things like auto-off when it is set down.
So the quality and speed of chips affects performance.
Sounds like marketing foo.
I have a 10+ year old Weller station with digital temp adjustment, and I don’t recall it having a cpu and ram.
Digital temp adjustment is different than a sensor that tells you the exact temp at the tip.
Pretty sure any 10+ year old unit is just setting a temp, not telling you the actual temp through a measurement.
The Weller WESD51 sets the temp at the tip and mine has done that since I bought it in 2016. A look at a datasheet dates it back to 2006 but it could be older. By definition that means it has to know what the tip temp is. As it heats up the digital display tracks the temp going up.
If it has digital temperature control then it has something resembling a CPU and memory. If it’s analog then it’s probably just not that accurate and will drift over time without manual calibration.
I have a pinecil and direct heat soldering irons blow away non direct heat irons like your weller (and I think this ifixit one). Once you switch you never want to go back. Which is really disappointing because I don’t think this new ifix it one is.
So, what’s updating the display? Power supply imps?